Model Tech Yak 54 User Manual download pdf (Page 14)

PAGE 14 OF 26

Install the rudder servo in the forward servo cut out with the output shaft to the rear.

Mark and use a 1/16 bit to drill the rudder servo mounting holes.

RUDDER PULL-PULL CABLE

INSTALLATION

Gather the rudder control linkage parts shown. 2

Rudder cables, 4 threaded couplers, and 4

brass swaging

tubes.

Feed the rudder cable through the cable exit

tube in the tail of the fuse toward the front of the

fuse.

Repeat on other side.

Insert rudder cable through the brass swage

tube, then through the threaded coupler hole,

and back through the brass swage tube as

shown.

Loop the cable back through the brass swage

tube as shown.

Tighten the second loop through the brass

swage tube and crimp the brass tube with a

crimping tool or pliers. Cut off excess cable as

shown.

A drop of thin CA may be applied to the

swage tube to help secure the cable

Repeat above steps for the other side rudder

cable.

Attach a ball link to each threaded coupler.

Attach the ball links to the

rudder servo arm and then attach the servo arm

to the rudder servo as shown. A 3” Air Wild arm

is recommended.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

No comments

Model Tech Yak 54 User Manual Page 14